Description

Seal critical connections with a two-part epoxy.
A 50 mL A/B epoxy cartridge developed for marine sealing, potting and bonding work. The 2:1 cartridge pairs a white paste (Part A) with a pale yellow, semi-transparent liquid (Part B). Use a compatible dispensing gun and the supplied static mixing nozzle to dispense a blended bead.
For ROV penetrations and marine assemblies.
Use this epoxy for potting cable entries and sealing the area around a hollow cable gland or through-bolt after the conductors pass through its central bore. It can also be used to bond suitable enclosure parts, hull components and panels. The supplied description lists ABS, ASA, acrylic, fiberglass composites, metal-to-metal and metal-to-plastic assemblies among its applications.
The cured joint is intended to resist seawater exposure, pressure and impact. Seal quality depends on the surface, joint geometry, dispensing and cure process; validate the finished assembly for its operating depth and conditions.
One cartridge for sealing and bonding work.
Pot cable penetrations
Fill around conductors at a through-bolt or hollow cable gland after routing the cable.
Bond different materials
Use on compatible plastics, fiberglass composites and metal assemblies after surface preparation.
Dispense a mixed bead
The included static mixing nozzles combine the two components during application.
Plan the cure
Initial set is listed as 1–2 hours; full cure is 24 hours at 25 °C.
Check the mixing and cure data.
| Capacity | 50 mL |
|---|---|
| A:B mixing ratio | 2:1 cartridge ratio |
| Part A appearance | White paste |
| Part B appearance | Pale yellow, semi-transparent liquid |
| Initial set | 1–2 hours |
| Full cure | 24 hours at 25 °C |
| Shear strength | ≥17 MPa (supplier stated) |
| Tensile strength | ≥80 MPa (supplier stated) |
| Hardness | 80 D (supplier stated) |
| Shelf life | 24 months (supplier stated) |

Prepare, mix, then allow a full cure.
Prepare surfaces
Clean the bonding or potting area. Keep surfaces dry and free of oil and grease.
Dispense evenly
Fit a supplied static mixing nozzle to the cartridge and use a compatible dispensing gun. Dispense until the components are uniformly mixed, then fill the prepared joint without leaving voids.
Allow to cure
Keep the assembly undisturbed while it sets. Allow 24 hours at 25 °C for full cure before assessing the finished seal.
Confirm compatibility with the actual substrates and potting design. A depth, pressure or IP rating for a finished assembly is not specified by the supplied product data.
Included in the package.
Marine epoxy AB adhesive kit
- 50 mL A/B epoxy cartridge 1
- 3.0 static mixing nozzle 2






