Description

Form and protect a larger inline cable joint.
A reusable PP mold for encapsulating inline cable connections. The two-part shell gives the splice a neat, tapered profile and makes demolding straightforward after the compound has cured.
A mold for underwater cable splice encapsulation.
Designed for cable joints in power, communications and signal lines. Typical application areas in the source material include municipal and water projects, landscape and street lighting, tunnels, and offshore environments such as subsea cable-network joints.
With a suitable vulcanizing or potting compound and a properly completed process, the molded joint can provide water isolation and mechanical protection. Pressure resistance and subsea use must be qualified for the complete cable-and-compound assembly.

Practical for repeated splice work.
Reusable PP body
The source lists the mold as reusable for multiple cycles. Inspect each half for damage and clean it between uses.
Easy demolding
The split shell can be opened after the encapsulant has fully cured, leaving a consistent, streamlined formed joint.
Cable protection
The formed compound surrounds the connection to support electrical isolation from moisture and add mechanical protection.
Specified service range
The supplier lists a −30 to 55 °C temperature range for the PP mold. Confirm suitability of the selected compound and cable separately.
Check fit and compound volume.
| Model | NX-A1 |
|---|---|
| Applicable cable outside diameter | 6–25 mm |
| Mold material | PP (polypropylene) |
| Supplier-listed temperature range | −30 to 55 °C |
| Mold reuse | Multiple cycles, subject to condition |
| Maximum stated formed size | 200 mm length × 30 mm outside diameter |
| Reference filling amount | 185 g per joint (supplier example) |

Size the joint as a complete assembly.
The listed 200 × 30 mm is the maximum formed size, not the empty mold’s shipping dimensions. The supplier’s 185 g filling figure references one joint using a 3 m pack of 2131B compound. Actual consumption changes with cable diameter, conductor arrangement, connector geometry and the selected compound; measure and validate your process before production.
The mold alone does not have a verified waterproof, depth or pressure rating. Follow the compound manufacturer’s working and curing instructions, then electrically and mechanically test the completed splice for its intended environment.
What is included.
NX-A1 kit
- NX-A1 mold set 1
- Small clips 3
- Insulation tape roll 1
Common questions
What is the 200 × 30 mm dimension?
It is the supplier’s maximum stated size of the formed splice.
Can the mold be reused?
Yes. The supplier describes multiple uses, subject to cleaning and inspection for damage between cycles.
Is this a rated underwater connector?
No numerical depth, pressure or IP rating is provided for the mold. The finished splice must be qualified as a complete assembly.






