Description

Shape a compact, sealed inline splice.
A semi-transparent, snap-together mold for vulcanized or resin-potted cable joints. Check the fill through the shell, allow trapped air to escape through two vent ports, and form a streamlined splice around 5–16 mm cable.
A defined form for the cable connection.
Use the shell as a mold for vulcanized cable joints or resin potting. With a compatible compound and a properly completed process, the encapsulated connection is designed to isolate the cable joint from water and air. The source material describes underwater cable joining with a compatible vulcanizing compound; qualify the finished assembly for its intended pressure and service conditions.
Applications include low-voltage power, communications and signal cables, as well as municipal works, water projects, landscape lighting, street lighting and tunnels.

Built around the fill and cable fit.
See the fill
The semi-transparent shell makes the potting or vulcanizing fill visible during assembly.
Release trapped air
Two vent openings help air escape while the mold is filled.
Snap-together halves
The matching halves clip together for assembly and removal.
Adapt the cable exits
Stepped end grooves allow the openings to be adjusted to the cable diameter.
Compact finished form
A 100 × 20 mm finished profile helps limit the amount of sealing compound used.
Inline cable route
The straight-through form keeps the cable joint aligned along one axis.
Match the cable before assembly.
| Applicable cable outside diameter | 5–16 mm |
|---|---|
| Referenced cable applications | Low-voltage cable up to 1 kV; communications and signal cable |
| Finished splice size | 100 mm length × 20 mm outside diameter |
| Shell | Semi-transparent, two-part clip design |
| Vent openings | 2 |
| Process note | 30 s operating time stated for the referenced vulcanizing compound |

A streamlined joint after vulcanization.
The illustrated finished splice is 100 mm long with a 20 mm outside diameter. These dimensions describe the formed joint, not the empty mold.

Select the kit quantity.
2-set kit
- Mold sets 2
- Insulation tape rolls 1
- Small screwdrivers 1
6-set kit
- Mold sets 6
- Insulation tape rolls 3
- Small screwdrivers 3
Common questions
Is 100 × 20 mm the mold size?
No. It is the stated size of the finished splice after vulcanization.
Does the mold itself carry a depth rating?
No numerical depth or pressure rating is supplied for the empty mold. Underwater suitability depends on the completed seal, materials and validation.
Is the 30-second figure a cure time?
The source notes a 30-second vulcanizing-compound operating time. Follow the actual compound instructions for working time and full cure.






