Description

Seal critical connections with a two-part epoxy.
This flowable A/B epoxy is supplied for potting and sealing work around motors, cable connections and enclosure interfaces. It is applied as a liquid and develops its protective properties after a full cure.
Made for marine equipment potting.
The supplier describes this customized epoxy as more flowable and resistant to heat and corrosion than its standard formulation. It is used around motor seals, wire joints and the internal or external sealing points of enclosures. Viscosity before cure depends on formulation and process.
Once fully cured, the supplier lists moisture and dust protection, electrical insulation, heat transfer, sealing and vibration protection among its functions. The finished assembly must be checked for its actual seawater exposure, pressure and operating conditions.
A measured process for reliable potting.
Motor interfaces
Encapsulate prepared electrical and sealing transitions in a suitable motor assembly.
Cable connections
Pot wire joints and cable exits after the conductors are positioned and the cavity is clean.
Enclosure sealing points
Fill suitable penetrations or interfaces on the inside or outside of an enclosure.
Control air bubbles
Use a careful pour or suitable vacuum process to reduce voids before the material cures.
Check the mixing and cure data.
| A:B mixing ratio | 4:1 by weight |
|---|---|
| Weighing accuracy | Within 0.1 g (supplier instruction) |
| Mixing time | About 1 minute |
| Surface dry at 25 °C | Approximately 6–8 hours |
| Full cure at 25 °C | Approximately 24 hours |
| Heat-cure option | 60 °C for 2 hours (supplier stated) |
| Maximum hardness | After 3 days (supplier stated) |
Temperature matters. Cure is generally faster in warmer conditions and slower in cooler conditions. Use the 60 °C option only when all components in the assembly tolerate that temperature. These times are supplier guidance; no finished-assembly depth or pressure rating is specified.
Prepare, weigh, fill, cure.
Prepare
Use a clean, dry container. Tare the scale and shake or stir both bottles to disperse any settled material.
Weigh and mix
Measure A:B strictly at 4:1 by weight. Add A first, then B, and stir thoroughly for about one minute. Close both bottles after use.
Fill the cavity
Keep the syringe tip below the resin surface when drawing material to avoid air intake. Dispense into the prepared area; vacuum degassing may be used when appropriate.
Allow to cure
Keep dust and strong light away. Check the surface during the first hour and remove visible bubbles. Allow approximately 24 hours at 25 °C for full cure.
Included in the package.
Marine epoxy AB potting kit
- Part A epoxy resin bottle · 500 g1
- Part B curing agent bottle · 100 g1






