Description

Give a larger cable joint a defined shape.
A semi-transparent two-part mold for straight-through cable splices. Its snap-fit halves, tapered cable exits, filling port and two air-release openings support a controlled vulcanizing or resin-potting process.
Encapsulate the connection in a split shell.
Use the mold to form a vulcanized or resin-potted inline cable joint. The semi-transparent shell lets the operator check the fill, while two air-release openings help reduce trapped bubbles. The matching halves clip together and can be separated for demolding after the chosen compound has cured.
With compatible materials and a properly completed process, the encapsulated connection is intended to isolate the cable joint from water and air. The supplier describes use in underwater cable joining; qualify the finished joint for its intended depth, pressure and service conditions.
Designed around filling and fit.
See the fill
The semi-transparent body helps you monitor the compound during application.
Vent trapped air
Two openings provide an escape route for air as the cavity fills.
Adjust cable exits
Stepped end grooves can be trimmed to fit the cable diameter, following the assembly procedure.
Open the two halves
Snap-together construction makes the shell convenient to assemble and remove after curing.
Check the cable and mold dimensions.
| Applicable cable outside diameter | 8–26 mm |
|---|---|
| Mold dimensions | 185 × 40 × 45 mm |
| Reference filling amount | Approximately 150 g |
| Cable application | Low-voltage power cable up to 1 kV; communications and signal cable |
| Supplier example: unarmored | 3 × 10.4 × 16 mm² |
| Supplier example: armored | 3 × 10.4 × 10 mm² |
| Shell design | Semi-transparent, two-piece snap fit; two vent openings |

For power and signal cable joints.
Supplier examples include power, communications and signal lines in municipal works, water projects, landscape and street lighting, and tunnels. Match the actual cable outside diameter and joint build-up to the cavity. The conductor sizes in the supplier chart are examples, not a substitute for checking cable OD.
The approximately 150 g fill amount is a planning reference. Actual consumption, working time, curing time and the finished seal depend on the cable, compound and installation method. No numerical depth, pressure or IP rating is supplied for the mold itself.
Included in the kit.
8–26 mm splice mold kit
- Mold set 1
- Insulation tape roll 1
- Cotton strip set 1
Common questions
Is 185 × 40 × 45 mm the finished joint size?
No. It is the stated product size of the mold. The final joint depends on the cavity and the completed cable assembly.
Can the mold be used for underwater joints?
The supplier describes underwater cable splicing with a suitable compound. The completed joint must be tested for its intended service conditions.
How much compound is needed?
The supplier gives approximately 150 g as a reference. Confirm the amount for the actual cable and joint design.






